The Xtracked SmartHub comes with a simple plug-and-play cable system to connect it to your command station. We provide different versions of the SmartHub for Lenz and Roco/Fleischmann in our shop, so be sure to get the right one. Each version comes with its own cable and can be connected in mere seconds. Below you will find detailed instructions per command station.
Did you know that the Xtracked App will guide you through this process during initial setup? Simply unbox your SmartHub and follow the instructions in the App for maximum ease of use.
Roco/Fleischmann 10764
Connect a Roco multiMAUS to the Master port of the 10764 command station. Then connect the black XpressNet cable that came with the SmartHub to the Slave port of the 10764. Connect the other end to the X-BUS port that’s on the back of the Xtracked SmartHub. it’s as simple as that, now start the Xtracked App and have fun.
Did you know that you can connect 3 additional XpressNet devices, like a multiMAUS, to the expansion ports on the front of the Xtracked SmartHub?
Roco/Fleischmann z21 start/Z21
Connect the black XpressNet cable that came with the Xtracked SmartHub to the X-BUS port on the front of the z21 start/Z21 command station. Connect the other end to the X-BUS port that’s on the back of the SmartHub. It’s as simple as that, now start the Xtracked App and have fun.
Note that in contrast to the 10764 command station, the z21 start/Z21 does not need a multiMAUS connected alongside the SmartHub.
Did you know that you can connect 3 additional XpressNet devices, like a multiMAUS, to the expansion ports on the front of the Xtracked SmartHub?
Comments
0 comments
Article is closed for comments.